![]() ![]() *Drive protection: surge protection, overvoltage protection *Is the power adjustable: PWM can be adjusted * Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal) can not engrave on stainless steel, alumina, Alloy, silver and other reflective metal. It is not possible to directly engrave the metal with strong mirror reflectivity, which may cause injury to the operator or burn the laser. Supported cutting material: Wood/ plywood/ leather/ paper. Supported engraving materials: Wood, gray paper, leather, bamboo, blackening plastics, rubber, alumina oxide, iron oxide, etc. The NEJE team continuously optimizes the optical system to make the optical power loss less than 1%, the focus point is clear, and the maximum cutting thickness can reach 8mm with the correct focus adjustment. With strong power, the engraving depth can reach 1.5-3mm in the engraving mode, and it can cut for a long time in continuous 100% power mode, which is suitable for cutting wooden blocks with a thickness of 3-5mm ( max 8mm ). ![]() It supports metal engraving including alumina oxide, iron oxide and other non-reflective materials (Especially good at cutting, It can cut wood (3-7mm). Cutting, metal engraving, drawing depth engraving, etc.
0 Comments
Leave a Reply. |